• en
  • cs
Disertační práce

Studium modelových katalyzátorů pomocí skenovací tunelové mikroskopie a rentgenové fotoelektronové spektroskopie za zvýšeného tlaku

Popis v angličtině

Heterogenous catalysis is the chemical reaction where the phase of catalysts differs from that of the reactants or products. Catalysts are used to increase the rate, effectivity and selectivity of reactions, thus enabling a large-scale product formation. Examples of such reactions are oxidation of CO on the surface of platinum, dissociation of molecular oxygen and hydrogen in the hydrogen fuel cell (electrocatalysis) or Haber-Bosch synthesis of ammonia.

To further increase the speed of reactions, most of the industrial heterogeneous catalysis is executed in high reactant pressure and temperature. This strongly contrasts with a huge body of experimental studies focused on catalyst surfaces in ultra-high vacuum conditions and relatively low temperature, i.e. in conditions that enable use of sensitive spectroscopic and microscopic techniques. Only lately, it has been shown that even simplest metallic catalyst surfaces significantly reconstruct under high pressure and temperature of reactants. This has led to emergence of a new branch of experimental surface science techniques, which are able to observe surfaces under so-called operando conditions. The techniques are often referred to as near-ambient pressure (NAP) techniques.

This dissertation thesis will focus on a combination of multiple NAP techniques: NAP scanning tunneling microscopy (NAP-STM), NAP scanning force microscopy (NAP-AFM), NAP X-ray photoelectron spectroscopy (NAP-XPS) and NAP ultraviolet photoelectron spectroscopy (NAP-UPS). All the methods are combined into one ultra-high vacuum apparatus and thus can be used in-situ. This unique combination of methods will be used to characterize catalytic surfaces and their topographic and chemical changes directly during the ongoing surface reactions.


  1. Bibliographic research and selection of interesting experimental systems for the NAP-STM/XPS study.
  2. Getting acquainted with the experimental methods: STM, AFM, XPS, UPS, LEED.
  3. Preparation of the samples.
  4. Characterization of the samples by methods of surface science, especially by the near-ambient pressure STM/AFM and XPS.
  5. Processing and analysis of the obtained data.
  6. Publication of the results. Writing the doctoral thesis.

21-Matvija.png (428 KB)


  1. Rev. Sci. Instrum. 84, 034101 (2013);
  2. Rev. Sci. Instrum. 87, 064101 (2016);
  3. J. Phys. Chem. B 108, 38 (2004)
  4. Science 327, 850-853 (2010)
  5. Science 351, 475−478 (2016)
  6. ACS Catal. 5, 6802−6806 (2015)
  7. J. Am. Chem. Soc. 135, 16781−16784 (2013)
  8. J. Am. Chem. Soc. 135, 12560–12563 (2013)

RNDr. Peter Matvija, Ph.D.

Odborný asistent
Detail osoby

Shiva Oveysipoor

Detail osoby

Studium, přednášky, zajímavosti a informace z oblasti nanomateriálů a vodíkových technologií.